woven label

How to know best woven label?

Color difference test: visually observe the belt surface without Yin and Yang color, color, texture (each ribbon needle edge must be a color) tape edge, cloth edge can not exchange.If the original version is available, it shall be compared with the original color of woven labels. Generally, customers’ requirements for similarity shall be more than 95%, and some strict customers’ requirements shall be more than 98%. If the color meets customers’ requirements, all the colors shall be matched again for printing.(therefore, it is suggested that the original version of woven mark and trademark can be provided. If there is no original version, the PANTON color number can be provided, and the color matching can be more accurate.)

Wool: through naked eye observation, the two surfaces that weave weave mark and flank cannot have the serious MAO qiu that affects to take a face or wool silk.

Drawnwork: through the naked eye observation, weaves the mark to be able not to have the jump needle.

Pollution: no oil, stain or dust on the surface of woven marks.

Above is the general naked eye judgment judgment ribbon quality good or bad method.The following is an introduction to the use of measurement:

Thickness detection: the tolerance shall not exceed 0.1mm

Width detection: the tolerance of woven mark with width above 1 “and 1″ shall not exceed 0.25;The weaving mark tolerance of 25MM and above shall not exceed 0.5mm;For the width of woven mark under 1 “and 25MM, the standard tolerance shall not exceed 0.25mm;Note: plain and herringbone straps must be enough to measure, but not more than 0.25 cents.